Pepperl Fuchs UC1000-18GS-2EP-IO-V15

Ultrasonic sensor. Single head system, IO-Link Interface for process data, parameterization and diagnosis, Programmable via DTM with PACTWARE, Programmable via IrDA (infrared interface), Series: UC-18GS, Operating voltage: 10 ... 30 V DC , ripple 10 % SS , Interface type: IO-Link (via C/Q = Pin 4), Interface type: IrDA (infrared interface), Output type: 2 push-pull (4 in 1) outputs, short-circuit protected, reverse polarity protected, UL approval: cULus Listed, Class 2 Power Source. Sensing range: 70 ... 1000 mm. Adjustment range: 90 ... 1000 mm. Dead band: 0 ... 70 mm. Standard target plate: 100 mm x 100 mm. Transducer frequency: approx. 255 kHz. Response delay: minimum : 28 ms factory setting: 56 ms. Sensor cycle time: ≥ 14 ms (factory setting) ; programmable to 60 s. Temperature influence: with temperature compensation: ≤ ± 0.75% of the end value 10 min after switching on the sensor (factory setting) with enhanced temperature compensation: ≤ ± 0.75% of the end value 2 min after switching on the sensor without temperature compensation: 0.17 %/K. Non-volatile memory: EEPROM. Write cycles: 300000. LED green: solid: power onflashing: standby mode or IO-Link communication. LED yellow: solid: object in evaluation rangeflashing: switch point programming, object detected. LED red: solid: errorflashing: switch point programming, object not detected. Operating voltage: 10 ... 30 V DC , ripple 10 %SS. No-load supply current: ≤ 50 mA. Power consumption: ≤ 700 mW. Time delay before availability: ≤ 300 ms. Interface type: IO-Link (via C/Q = Pin 4). IO-Link revision: 1.1. Device profile: Smart Sensor Profile 2. Process data width: 32 bit. Device ID: 0x300603 (3147267). Transfer rate: COM2 (38.4 kBit/s). Min. cycle time: 3 ms. SIO mode support: yes. Compatible master port type: Class A Class B (use 3-pole adapter or 3-wire cable). Interface type: IrDA (infrared interface). Mode: point-to-point connection. Transfer rate: 115.2 kBit/s. Maximum communication distance: 5 cm. Input/output type: 1 synchronization connection, bidirectional. 0 Level0 ... 1 V1 Level2.5 V ... UBInput impedance> 22 kΩOutput currentcurrent source 22 kΩ. Output current: current source BR>PA, PC, POM and PBT plastic partsTransducerepoxy resin/hollow glass sphere mixture; polyurethane foam: . Housing: stainless steel (1.4305 / AISI 303)>BR>PA, PC, POM and PBT plastic parts. Transducer: epoxy resin/hollow glass sphere mixture; polyurethane foam. Installation position: any position. Mass: 45 g. Tightening torque, fastening screws: max. 30 Nm. Dimensions: . Length90 mmDiameter18 mm: . Length: 90 mm. Diameter: 18 mm. Output 1: near switch point: 90 mm far switch point: 1000 mm output function: Window mode output behavior: NO contact. Output 2: near switch point: 90 mm far switch point: 500 mm output function: Window mode output behavior: NO contact. Beam width: wide

Specifications